Versions Compared

Old Version 15

changes.mady.by.user Editor

Saved on

compared with

New Version 16

changes.mady.by.user Editor

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Configuring your SMDR output

Connect to your Avaya Communications Manager using an RS232 or IP terminal client and, after logging in with your administrative credentials, follow the steps below:

Configuring node-names ip

You will need to use the Issue the change node-names command to add a new node. You will have two fields which are required to be populatedTwo fields need to be specified as follows:

  • Name: In this field please enter in TIMPlus.
  • IP Address: This needs to be set to  (the IP Address address of the machine that running TIM Plus is installed on.

...

  • )

Here is an example of a

Referencemacro
Labelnode-names
configuration
 configuration:

Screenshotmacro
Borderfalse
URLhttp://docs.call-logger.com:8090/download/attachments/4817070/avaya_communications_manager_1.png

Configuring ip-services

You will need to use Issue the change ip-services command to add /ammend ip-or amend IP services. There are three pages that need to be configured, below you will find, by page the fields that need to be configured.In to configure:

On Page 1, you will have the following fields which are required to be populated:

  • Service type: This needs to be set to CDR1.
  • Local Node: This needs to be set  (set this to the node-name of the CLAN board.)
  • Local Port: This  0 (this cannot be changed, it is always set to 0.)
  • Remote Node: This needs to be set to the TIMPlus (the same node-name which was as created in the the node-names section which should be TIMPlus. section above)
  • Remote Port: This is (the TCP port that TIM Plus will be listening on. Generally the 9000 range is normally free so we could recommended you select one from there.

...

  • use to listen for CDR data, e.g.
    Keywordmacro
    Label9000
    )

Here is an example of an ip-services configuration , Page (page 1):

Screenshotmacro
Borderfalse
URLhttp://docs.call-logger.com:8090/download/attachments/4817070/avaya_communications_manager_2.png

In On Page 2, no configuration changes are needed.

In On Page 3, you will have the following fields which are required to be populated:

  • Reliable Protocol: This needs to be set to n.

  • Packets Resp Timer:

    Please leave this as

     30 (the default

    , which is 30.

    )

  • Sessions Connect Message Cntr: Please leave this as the default, which is 3.
  • SPDU Cntr: Please leave this as the default, which is 3.
  • Connectivity Timer: Please leave this as the default, which is 60.

...