Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

These instructions help you configure your Cisco UCME / UC500 to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Pbxsummary
Supportfiles1Cisco UCME - RADIUS.TDT
Supportfiles2Cisco UCME - RADIUS.TDS
ConnectionRADIUS connection
RequiredTask1Configure UCME to send RADIUS events
RequiredTask2Configure Cisco AXL sync
RequiredTask3Configure TIM Enterprise to capture RADIUS packets

HTML
<a id="Configure UCME to send RADIUS events"></a>

Configuring UCME to send RADIUS events

Use Telnet to connect to the IP address of your UCME as shown below:

Screenshotmacro

Once connected, enter the following commands to enable the UCME to send RADIUS events to TIM Enterprise:

StepIOS commandsDescription
1enableCauses the UCME to enter EXEC mode. Type your EXEC password if requested
2conf tEnters the global configuration mode
3aaa new-modelEnables aaa accounting mode
aaa accounting connection h323 start-stop group RADIUS
gw-accounting aaa
acct-template callhistory-detail
4RADIUS-server host 192.168.0.1 auth-port 0 acct-port 1612Specifies the IP address and port of TIM Plus's RADIUS, to which CDR data will be sent, e.g. 192.168.0.1:1612
5RADIUS-server key C1scoSpecifies a RADIUS authentication secret that will be used by TIM Plus (configured in the next section), e.g. C1sco
6RADIUS-server vsa send accounting
Enables VSA events
7endExits configuration mode
8wrSaves the changes

Configuring Cisco AXL sync

Follow the steps below to configure TIM Enterprise to perform directory synchronisation with your Cisco UCME:

  1. Click on the Directory tab.
  2. Go to the Directory level where you want the synched files to be created and add a new Directory Sync object. Enter a name for the object and click on the Add button, as shown below:
    Screenshotmacro