Overriding report parameters

Each report has its own parameters, most of which are common to all reports

...

and these are normally set using the Report Selection Criteria window

...

. However, you can override these parameters by modifying the settings in the main configuration file.

...

If a user

...

sets a specific parameter in the

...

...

amend certain settings, for example the percentage mark-up in a billing report.

Each report has its own ID number - the Billing Report has an ID of 2. This corresponds to the setting in the main configuration file that you need to alter.

As an example, let's fix the % we can set the percentage mark-up in every Billing Report to 50% and set the a surcharge to of £1.00.

You can edit the main configuration file by editing main.cfg using Notepad or something similar. This file is located in c:\tim\config, and in the section entitled [Report Customisations], add or amend the line Report2Extra to read:

Report2Extra = &markup=50&surcharge=1.00

From now on, when a billing report (ID = 2) is run, these extra settings are forced upon the reporting engine and override any values that the user selected.

...

To apply these settings, you need to edit the 

Open the the 

Report2Extra = &markup=50&surcharge=1.00</span></p>

<p>From now on, when a billing report (ID = 2) is run, these extra settings are forced upon
the reporting engine and override any values that the user selected.</p>

<p><b>Tel:</b> +44 (0)20 7265 2626 </p>
<p><b>E-mail:</b> support@tri-line.com </p>

00

In the example above, when a Billing Report is run, these extra settings are forced upon the reporting engine and override any values that the user has selected.