AGFEO AC-AS Series

These instructions help you configure your AGFEO AC-AS phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Plus establishes a serial connection with this PBX.

Support Files

  AGFEO AC-AS Series.TDT

Required Tasks

  $paramRequiredTask1

Configuring your SMDR

AGFEO AC-AS Series sends SMDR information via a serial connection. You will need to directly connect a serial cable from the AGFEO AC-AS Series to a PC that will be running NetPbx software.

For more information about the output and configuration of the SMDR data, please contact your phone maintainer.

Installing NetPBX

The AGFEO AC-AS Series sends SMDR information via a serial connection. To collect the data from the serial port, you will first need to install NetPbx software,which then sends the SMDR to TIM Plus. For setup instructions, click on the link below:

Install and configure NetPbx

Configuring TIM Plus

Once NetPbx is configured and collecting data, log on to TIM Plus as usual and apply the following settings:

1. Click on the Directory tab.
2. Select the site configured during the setup wizards and click Properties.
3. Within the Site properties, select AGFEO AC-AS Series from the PBX model drop-down list.
   
   
4. In the Connection method field, select No connection required from the drop-down list.
5. Click on Save to apply the changes.

These instructions should assist in configuring your AGFEO AC-AS Series to work with TIM Plus. If you are not familiar with PBX configuration, please contact your system maintainer.

Configuring TIM Plus

Below you will find steps on how to configure TIM Plus to listen for SMDR data from your AGFEO AC-AS Series:

1. Browse to TIM Plus as normal and login with your credentials.
2. Click on the Directory tab.
3. Click on the site configured during the setup wizard and click Properties or create a new site and click Properties.

4. Within the Site Properties window, select AGFEO from the PBX model drop-down list.
5. In the Connection method field select No connection required from the drop-down list.
6. Finally, click on the Save button.