Siemens Realitis/HiPath DX - Serial connection

These instructions help you configure your Siemens Realitis/HiPath DX phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Plus establishes a serial connection with this PBX.

Support Files

  Siemens HiPath DX.TDT
  Siemens HiPath DX.TDS

Required Tasks

  Configure your CIL output
  Install NetPBX
  Configure TIM Plus

Configuring your CIL output

The Siemens Realitis/Hipath DX sends CIL information via a serial connection. You will need to directly connect a serial cable from the Siemens Hipath DX v.24 wall box to the PC that NetPBX is installed and running on.

You will need to speak to your system maintainer to enable CIL output. They will need to set CIL output to Full orunrestricted CIL format.

Installing NetPBX

To collect the data from the serial port and send it to TIM Plus, you will first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

Configuring TIM Plus

Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:

1. Click on the Directory tab.
2. Select the site configured during the setup wizard and clickProperties.
   
   
3. Within the Site Properties window, select Siemens HiPath DX from the PBX model drop-down list.
4. In the Connection method field, select No connection required from the drop-down list
5. Click on the Save button to save the settings.