You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus captures RADIUS packets from this PBX.
Support Files
Cisco UCME - RADIUS.TDT
Cisco UCME - RADIUS.TDS
Required Tasks
Configure UCME to send RADIUS events
Configure Cisco AXL sync
Configure TIM Plus to capture RADIUS packets
Configuring UCME to send RADIUS events
Use Telnet to connect to the IP address of your UCME as shown below:
Once connected, enter the following commands to enable the UCME to send RADIUS events to TIM Plus:
| Step | IOS commands | Description |
|---|---|---|
| 1 | enable | Causes the UCME to enter EXEC mode. Type your EXEC password if requested |
| 2 | conf t | Enters the global configuration mode |
| 3 | aaa new-model | Enables aaa accounting mode |
| aaa accounting connection h323 start-stop group RADIUS | ||
| gw-accounting aaa | ||
| acct-template callhistory-detail | ||
| 4 | RADIUS-server host 192.168.0.1 auth-port 0 acct-port 1612 | Specifies the IP address and port of TIM Plus's RADIUS, to which CDR data will be sent, e.g. 192.168.0.1:1612 |
| 5 | RADIUS-server key C1sco | Specifies a RADIUS authentication secret that will be used by TIM Plus (configured in the next section), e.g. C1sco |
| 6 | RADIUS-server vsa send accounting | Enables VSA events |
| 7 | end | Exits configuration mode |
| 8 | wr | Saves the changes |
Configuring Cisco AXL sync
Follow the steps below to configure TIM Plus to perform directory synchronisation with your Cisco UCM:
- Click on the tab.
- Choose the site you want to configure and click .
- In the Site Properties window, select the tab.
- Tick the option entitled Synchronise with the following device .
- In the Host field, enter the IP address of your UCME.
- In the Port field, enter the port number of the IOS service, e.g. 23 .
- In the Username field, enter the username of the IOS login that can perform synchronisation.
- Click on the button and enter the password of the IOS login that can perform synchronisation.
- Click on the button to apply the changes.
Configuring TIM Plus to capture RADIUS packets
Follow the steps below to configure TIM Plus to receive RADIUS data from your UCME:
- Click on the tab.
- Choose the site you want to configure and click .
- In the Site Properties window, select Cisco UCME - RADIUS from the PBX model drop-down list.
- In the Connection method field, select RADIUS connection from the drop-down list.
In the Client IP field, enter the IP address of your UCME.
In the Secret field, enter the RADIUS-server key you configured on your UCME in the section above, e.g. C1sco .
Click on the button to apply the settings.
Labels: