You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your NEC NEAX phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus establishes a serial connection with this PBX.
Support Files
NEC NEAX.TDT
NEC NEAX.TDS
Required Tasks
Configure the SMDR output
Install NetPBX
Configure TIM Plus
Configuring your SMDR output
Using the CAT (Customer Administration Terminal) enter the following settings in the system-programming mode:
| Field name | Details | ||
|---|---|---|---|
| CM40 | Output port & attributes defaults: 9600 baud, 8 data bits, no parity, 2 stop bits, DTR/RTS flow control. | ||
| CM13+05 | Enable SMDR for incoming calls to required stations. | ||
| CM13+06 | Enable SMDR for outgoing calls to required stations. | ||
| CM35+14 | Enable SMDR for outgoing calls to required trunk routes. | ||
| CM35+49 | Enable SMDR for incoming calls to required trunk routes. | ||
| CM08 | If SMDR for incoming calls is enabled, specify whether it applies to all incoming calls or only to those with Account Codes. Include ANI/Caller ID for incoming calls.
|
Installing NetPBX
If your NEC NEAX has been configured to send SMDR data via a serial connection, you first need to install the NetPBX software to collect the data from the serial port and send it to TIM Plus. For setup instructions, click on the link below:
Configuring TIM Plus
Once NetPBX is configured and collecting data, log in to TIM Plus and perform the steps below:
- Click on the tab.
- Choose the site you want to configure and click.
- Within the Site Properties window, select NEC NEAX from the PBX model drop-down list.
- In the Connection method field, select No connection required from the drop-down list.
- Click on the button to apply the settings.