Coral

These instructions help you configure your Coral Flexicom phone system to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Enterprise establishes a serial connection with this PBX.

Support Files

  Coral Flexicom 200.TDT

Required Tasks

  Configure the SMDR output
  Install NetPBX
  Configure TIM Enterprise

Configuring your SMDR output

The Coral Flexicom phone system sends its SMDR data via a serial connection. You need to directly connect a serial cable from the phone system to the PC that NetPBX is installed and running on.

For more information about the output and configuration of your SMDR data, contact your system maintainer.

Installing NetPBX

To collect call logging data from the serial port and send it to TIM Enterprise, you need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

Configuring TIM Enterprise

Once NetPBX is configured and collecting data, log in to TIM Enterprise and perform the following steps:

1. Click on the Directory tab.
2. Choose the PBX object you want to configure and click Properties.
3. A new window will open. In the General tab, select Coral Flexicom 200 from the Data format list and tick the Keep a local backup of data box, as shown below: 
   
   
4. In the Connection tab, select No connection required from the Connection method list.
5. Click on the Save button to apply the settings.
   
   

These instructions should assist in configuring your Coral to work with TIM Enterprise. If you are not familiar with PBX configuration, please contact your system maintainer.

For your SMDR configuration, you will need to speak to your system maintainer to enable SMDR output.

Configuring TIM Enterprise

Below you will find steps on how to configure TIM Enterprise to listen for SMDR data from your Coral Flexicom 200:

1. Browse to TIM Enterprise as normal and login with your credentials.
2. Click on the Directory tab.
3. Go the the point in the Directory where you need to add the PBX Object and add a PBX with the name 'Coral'.
4. Left-click on it and select Properties.
5. From the General settings tab select your Coral family PBX model from the list.

6. In the Connection tab select No connection required from the Connection method list.
7. Finally, click on the Save button.