Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History
<< Previous Version 14 Next >>

These instructions help you configure your Cisco UCME / UC500 to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Enterprise captures RADIUS packets from this PBX.

Support Files
  Cisco UCME - RADIUS.TDT
  Cisco UCME - RADIUS.TDS
Required Tasks
  Configure UCME to send RADIUS events
  Configure Cisco AXL sync
  Configure TIM Enterprise to capture RADIUS packets

Configuring UCME to send RADIUS events

Use Telnet to connect to the IP address of your UCME as shown below:


Once connected, enter the following commands to enable the UCME to send RADIUS events to TIM Enterprise:

StepIOS commandsDescription
1enableCauses the UCME to enter EXEC mode. Type your EXEC password if requested
2conf tEnters the global configuration mode
3aaa new-modelEnables aaa accounting mode
aaa accounting connection h323 start-stop group RADIUS
gw-accounting aaa
acct-template callhistory-detail
4RADIUS-server host 192.168.0.1 auth-port 0 acct-port 1612Specifies the IP address and port of TIM Enterprise's RADIUS, to which CDR data will be sent, e.g. 192.168.0.1:1612
5RADIUS-server key C1scoSpecifies a RADIUS authentication secret that will be used by TIM Enterprise (configured in the next section), e.g. C1sco
6RADIUS-server vsa send accounting
Enables VSA events
7endExits configuration mode
8wrSaves the changes

Configuring Cisco AXL sync

Follow the steps below to configure TIM Enterprise to synchronise with the directory of your your Cisco UCME:

  1. Click on the Directory tab.
  2. Go to the Directory level where you want to sync the UCME files and add a new Directory Sync object. Enter a name for the object and click on the Add button, as shown below:

  3. Left-click on the newly-created object and select Properties.
  4. In the Directory type drop-down list, select Cisco UCME.
  5. In the Host name field, enter the IP address of your UCME.
  6. In the Host port field, enter the port number of the IOS service, e.g. 23 .
  7. In the Username field, enter the username of the IOS login that can perform synchronisation.

  8. Click on Set password button and enter the password of the IOS login that can perform synchronisation.

  9. Click on the Save button to apply the changes.

Configuring TIM Enterprise to capture RADIUS packets

Follow the steps below to configure TIM Enterprise to receive RADIUS data from your UCME:

  1. Click on the Directory tab.
  2. Locate the PBX object you want to configure in the Directory, right-click on it and select Properties.
  3. A new window will open, displaying the general properties of your PBX object. Select Cisco UCME - RADIUS from the Data format list and tick the Keep a local backup of data box, as shown below:

  4. Click on the Connection tab and select RADIUS connection from the Connection method list.
  5. In the Client IP field, enter the IP address of your UCME.
  6. In the Secret key field, enter the RADIUS-server key you configured on your UCME in the section above, e.g. C1sco.

  7. Click on the Save button to apply the settings.

 

Labels:
None
Edit Labels