These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
<a id="Set up RADIUS events in the UCME"></a> |
Login to your Cisco UCME / UC500 via telnet, as shown below:
Now just enter the following RADIUS commands:
| Step | IOS commands | Description |
|---|---|---|
| 1 | enable | Enter EXEC mode, enter password if requested. |
| 2 | conf t | Enter global configuration mode. |
| 3 | aaa new-model | Enable aaa accounting mode. |
| aaa accounting connection h323 start-stop group RADIUS | ||
| gw-accounting aaa | ||
| acct-template callhistory-detail | ||
| 4 | RADIUS-server host 192.168.1.1 auth-port 1645 acct-port 1612 | Specifies the IP address to send CDR data. Where '192.168.1.1' is the machine running TIM Plus. |
| 5 | RADIUS-server key C1sco | Specifies the RADIUS authentication secret as 'C1sco' as configured above. |
| 6 | RADIUS-server vsa send accounting | Enables VSA events. |
| 7 | end | Exit configuration mode. |
| 8 | wr | Save changes. |