These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure UCME to send SysLog events"></a>

Configuring UCME to send SysLog events

Login to your Cisco UCME / UC500 via telnet, as shown below:

Now just enter the following SysLog commands:

<a id="Configure Cisco AXL sync"></a>

Configuring Cisco AXL sync

Below you will find steps on how to configure the Directory Sync from Cisco UCM:

1. Browse to TIM Plus as normal and login with your credentials.
2. Click on the Directory tab.
3. Click on the site configured during the setup wizard and click Properties or create a new site and click Properties.
4. Within the Site Properties window, select the Sync tab.
5. Click on the Synchronise with the following device tick box.
   
6. In the Host field, enter the IP Address of your UCME / UC500.
7. In the Username field, enter the username used to login to your UCME / UC500.
8. Click on the Set button and enter the password used to login to the UCME / UC500, then click OK.
9. Finally, click on the Save button to apply the settings.

<a id="Configure TIM Plus to capture SysLog packets"></a>

Configuring TIM Plus to capture SysLog packets

Below you will find steps on how to configure TIM Plus to receive data from your Cisco UCM:

1. Browse to TIM Plus as normal and login with your credentials.
2. Click on the Directory tab.
3. Select the site configured during the setup wizard and click Properties.
   
4. Within the Site Properties window, select Cisco UCME - SysLog from the PBX model drop-down list.
5. In the Connection method field, select SysLog connection from the drop-down list.
6. In the Client IP field, enter in the IP Address of the Cisco UCME / UC500.
7. Finally, click on the Save button to apply the settings.