These instructions help you configure your LG iPECS phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure the SMDR output"></a>

Configure the SMDR output

The SMDR output in LG iPECS is disabled by default. To enable the output, you need to amend the following settings in the programming sections below:

SMDR Attributes (PGM 177)
FieldDescription
Save EnableLeave this as the default, which is unticked
Print EnableThis needs to be enabled by clicking on the check box
SMDR Record Call TypeThis needs to be set to 'All Calls', you will need to select this from the drop-down list
Records In DetailThis needs to be enabled by clicking on the check box
Print Incoming CallThis needs to be enabled by clicking on the check box
Print Lost CallThis needs to be enabled by clicking on the check box
SMDR Dial Digit HiddenLeave this as the default which is '0'
SMDR Currency UnitLeave this as the default which is blank
SMDR Cost Per Metering PulseLeave this as the default which is blank
SMDR FractionLeave this as the default which is '0'
SMDR Start TimeLeave this as the default which is '0'
SMDR Hidden DigitLeave this as the default which is 'Right'
Long Distance Call Digit CounterLeave this as the default which is '0'
Long Distance Code (Max 2 Digits)Leave this as the default
MSN Print on SMDRLeave this is the default which is unticked
Print Caller NumberThis needs to be enabled by clicking on the check box

Here is an example of a populated SMDR Attributes screen:

Printer Port Selection (PGM 175)

In the Printer Port Selection (PGM 175) window, set Info/On-line SMDR to COM1/COM2 to send call logging data by serial port.

ISDN Attributes (PGM 200)

To enable CLI information in the call records produced by your LG iPECS, you need to set the CLI Print To Serial to ON, as shown below:

<a id="Install NetPBX"></a>

Installing NetPBX

If your LG iPECS has been configured to send SMDR data via a serial connection, you first need to install the NetPBX software to collect data from the serial port and send it to TIM Plus. For setup instructions, click on the link below:

Install and configure NetPBX

<a id="Configure TIM Enterprise"></a>

Configuring TIM Enterprise

Once NetPBX is configured and collecting data, log in to TIM Enterprise and perform the following steps:

  1. Click on the Directory tab.
  2. Choose the PBX object you want to configure and click Properties.
  3. A new window will open. In the General tab, select AGFEO AC-AS Series from the Data format list and tick the Keep a local backup of data box, as shown below:
  4. In the Connection tab, select No connection required from the Connection method list.
  5. Click on the Save button to apply the settings.