These instructions help you configure your Mitel 3100 phone system to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure the SMDR output"></a>

Configuring your SMDR output

Follow the steps below to configure your Mitel 3100 to output SMDR data via a serial connection:

1. Using an RS-232 cable, connect the PC running TIM Enterprise to the serial port of the Mitel 3100.
2. Launch the Mitel System Tool.
3. Choose Voice from the selection menu.
4. Click on the Management tab, select Call Logging.
5. Click Change to set the following parameters:
• Set the Cost per minute to 00. (This functionality is not supported in NA systems)
• Set the Minimum call duration to be recorded option to 00:00:00.
• Set the Type of calls option to All. 
• Set the Minimum page length to 1.
• Enable call logging.
6. Click Save and commit the changes.

<a id="Install NetPBX"></a>

Installing NetPBX

The Mitel 3100 phone system sends SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Enterprise, you first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

<a id="Configure TIM Enterprise"></a>

Configuring TIM Enterprise

Once NetPBX is configured and collecting data, log in to TIM Enterprise and perform the following steps:

1. Click on the Directory tab.
2. Choose the PBX object you want to configure and click Properties.
3. A new window will open. In the General tab, select Mitel 3100 from the Data format list and tick the Keep a local backup of data box, as shown below:
   
4. In the Connection tab, select No connection required from the Connection method list.
5. Click on the Save button to apply the settings.