Samsung DCS

These instructions help you configure your Samsung DCS phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Plus establishes a serial connection with this PBX.

Support Files

  Samsung DCS.TDT
  Samsung DCS.TDS

Required Tasks

  Configure the SMDR output
  Install NetPBX
  Configure TIM Plus

Configuring your SMDR output

Below you will find instructions on how to configure your Samsung DCS to output SMDR to TIM Plus. You will need to do this from a LCD handset. Just use the down arrow key to move to each option.

1. Open Programming and select 725.

2. Program each option as stated below:

   SMDR field	Value
   Page Header	Yes
   Lines per page	1
   Incoming Call	Yes
   Outgoing Call	Yes
   Authorise Code	Yes
   SMDR Start Time	Yes
   In/Out Group	No
   DND Calls	No
   Wake-Up Calls	No
   Directory Names	None
   Caller ID Data	Yes
   Abandoned Call	Yes
   No of Dial Mask	00
   DID Num/Name	Yes

3. Next, press the SPKR key.
4. Select 804.
5. Dial 0 and use the arrow keys and select SMDR.
6. Press the TRSF key.

Installing NetPBX

The Samsung DCS phone system sends SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Plus, you will first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

Configuring TIM Plus

Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:

1. Click on the Directory tab.
2. Select the site configured during the setup wizard and clickProperties.
   
   
3. Within the Site Properties window, select Samsung DCS from the PBX model drop-down list.
4. In the Connection method field, select No connection required from the drop-down list.
5. Click on the Save button to apply the settings.