NEC DXE

These instructions help you configure your NEC DXE e phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Plus establishes a serial connection with this PBX.

Support Files

  NEC DXE.TDT
  NEC DXE.TDS

Required Tasks

  $paramRequiredTask1

Configure your SMDR output

The NEC DXE phone system sends SMDR information via a serial connection. You will need to directly connect a serial cable from the NEC DXE phone system to the PC that NetPBX software is installed and running on.

However, the NEC DXE doesn't have SMDR output enabled by defalut, so you will need to speak with your phone maintainer for more information about the output configuration.

Installing NetPBX

The NEC DXE phone system sends SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Plus, you will first need to install NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

Configuring TIM Plus

Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:

1. Click on the Directory tab.
2. Select the site configured during the setup wizard and clickProperties.
   
   
3. Within the Site Properties window, select NEC DXE from the PBX model drop-down list.
4. In the Connection method field select No connection required from the drop-down list.
5. Click on the Save button to apply the changes.
   
   

These instructions should assist in configuring your NEC DXE to work with TIM Plus. If you are not familiar with PBX configuration, please contact your system maintainer.

By default the NEC DXE doesn't have SMDR enabled. You will need to speak to your system maintainer to get SMDR enabled.

Configuring TIM Plus

Below you will find steps on how to configure TIM Plus to listen for SMDR data from your NEC DXE:

1. Browse to TIM Plus as normal and login with your credentials.
2. Click on the Directory tab.
3. Click on the site configured during the setup wizard and click Propertiesor create a new site and click Properties.

4. Within the Site Properties window, select NEC DXE from the PBX model drop-down list.
5. In the Connection method field select No connection required from the drop-down list.
6. Finally, click on the Save button.