You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus captures RADIUS packets from this PBX.
Support Files
Cisco UCME - RADIUS.TDT
Cisco UCME - RADIUS.TDS
Required Tasks
Set up RADIUS events in the UCME
Configure the AXL sync
Configure TIM Plus to capture RADIUS packets
Configuring your UCME
Set up RADIUS events in the UCME
Login to your Cisco UCME / UC500 via telnet, as shown below:
Now just enter the following RADIUS commands:
| Step | IOS commands | Description |
|---|---|---|
| 1 | enable | Enter EXEC mode, enter password if requested. |
| 2 | conf t | Enter global configuration mode. |
| 3 | aaa new-model | Enable aaa accounting mode. |
| aaa accounting connection h323 start-stop group RADIUS | ||
| gw-accounting aaa | ||
| acct-template callhistory-detail | ||
| 4 | RADIUS-server host 192.168.1.1 auth-port 1645 acct-port 1612 | Specifies the IP address to send CDR data. Where '192.168.1.1' is the machine running TIM Plus. |
| 5 | RADIUS-server key C1sco | Specifies the RADIUS authentication secret as 'C1sco' as configured above. |
| 6 | RADIUS-server vsa send accounting | Enables VSA events. |
| 7 | end | Exit configuration mode. |
| 8 | wr | Save changes. |
Configuring TIM Plus
Configuring Cisco AXL sync
Below you will find steps on how to configure the Directory Sync from Cisco UCM:
- Browse to TIM Plus as normal and login with your credentials.
- Click on the tab.
- Click on the site configured during the setup wizard and click or create a new site and click .
- Within the Site Properties window, select the tab.
- Click on the Synchronise with the following device tick box.
- In the Host field enter in the IP Address of your UCME / UC500.
- In the Username field enter in the username to login to your UCME / UC500.
- Click on the button and enter the password used to login to the UCME / UC500, followed by clicking .
- Finally, click on the button.
Configuring TIM Plus to receive FTP
Below you will find steps on how to configure TIM Plus to receive data from your Cisco UCM:
- Browse to TIM Plus as normal and login with your credentials.
- Click on the tab.
- Select the site configured during the setup wizard and click .
Labels: