You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Siemens HiCom/HiPath phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus establishes a serial connection with this PBX.
Support Files
Siemens HiCom-HiPath.TDT
Siemens.TDS
Required Tasks
Configure the SMDR output
Install NetPBX
Configure TIM Plus
Configuring your SMDR output
The Siemens HiCom/HiPath phone system sends SMDR information via a serial connection. You will need to directly connect a serial cable from the Siemens HiCom/HiPath phone system to the PC that NetPBX is installed and running on.
For more information about the output and configuration of your SMDR data, please contact your phone maintainer.
Installing NetPBX
To collect the data from the serial port and send it to TIM Plus, you will first need to install the NetPBX software. For setup instructions, click on the link below:
Configuring TIM Plus
Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:
- Click on the tab.
- Select the site configured during the setup wizard and click.