You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus captures SysLog packets from this PBX.
Support Files
Cisco UCME - SysLog.TDT
Cisco UCME - SysLog.TDS
Required Tasks
Configure UCME to send SysLog events
Configure Cisco AXL sync
Configure TIM Plus to capture SysLog packets
Configuring UCME to send SysLog events
Log in to your phone system via Telnet, using the IP address of your Cisco UCME / UC500, as shown below:
Once connected, enter the following commands to enable the Cisco UCME / UC500 to send SysLog events to TIM Plus:
| Step | IOS commands | Description |
|---|---|---|
| 1 | enable | Enter EXEC mode, enter password if requested. |
| 2 | conf t | Enter global configuration mode. |
| 3 | aaa new-model | Enable aaa accounting mode. |
| aaa accounting connection h323 start-stop group SysLog | ||
| gw-accounting syslog | ||
| acct-template callhistory-detail | ||
| 4 | logging 192.168.0.1 | Specifies the IP address to send CDR data. Where '192.168.1.1' is the machine running TIM Plus. |
| 5 | end | Exit configuration mode. |
| 6 | wr | Save changes. |
Configuring Cisco AXL sync
Below you will find steps on how to configure the Directory Sync from Cisco UCM:
- Browse to TIM Plus as normal and log in with your credentials.
- Click on the tab.
- Select the site configured during the setup wizard and click .
- Within the Site Properties window, click on the tab and tick the box Synchronise with the following device.
- In the Host field, enter the IP address of your UCME / UC500.
- In the Username field, enter the username used to log in to your UCME / UC500.
- Click on the button and enter the password used to log in to the UCME / UC500.
- Click on the button to apply the settings.
Configuring TIM Plus to capture SysLog packets
Below you will find steps on how to configure TIM Plus to receive data from your Cisco UCM:
- Browse to TIM Plus as normal and log in with your credentials.
- Click on the tab.
- Select the site configured during the setup wizard and click .
- Within the Site Properties window, select Cisco UCME - SysLog from the PBX model drop-down list.
- In the Connection method field, select SysLog connection from the drop-down list.
- In the Client IP field, enter in the IP address of the Cisco UCME / UC500.
- Click on the button to apply the settings.
Labels: