SpliceCom Maximiser

These instructions help you configure your SpliceCom Maximiser phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

  TIM Plus establishes a TCP connection to this PBX.

Support Files

  SpliceCom Maximiser.TDT
  SpliceCom Maximiser.TDS

Required Tasks

  Configure the SMDR output
  Configure TIM Plus

Configuring the SMDR output

The SMDR output on the SpliceCom Maximiser is enabled by default, however, you will need to check with your system maintainer whether a Call Logging password has been set up in the phone system and if so, you will need to enter this in TIM Plus to enable the connection.

Configuring TIM Plus

Below you will find steps on how to configure TIM Plus to collect the SMDR data from your SpliceCom Maximiser:

1. Browse to TIM Plus as normal and log in with your credentials.
2. Click on the Directory tab.
3. Select the site configured during the setup wizard and click Properties.
   
   
4. Within the Site Properties window, select SpliceCom Maximiser from the PBX model drop-down list.
5. In the Connection method field, select Actively connect to PBX from the drop-down list.
6. In the Host field, enter the IP address of your SpliceCom Maximiser.
7. In the Port field, enter 4001.
8. Leave the Username field blank.
9. Leave the Password field blank, unless you've set up a Call logging password in your phone system.
   
10. In the Connection script field, select SpliceCom Maximiser from the drop-down list.
11. Click on the Save button to apply the changes.