You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Cisco UCME / UC500 to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Enterprise captures SysLog packets from this PBX.
Support Files
Cisco UCME - SysLog.TDT
Cisco UCME - SysLog.TDS
Required Tasks
Configure UCME to send SysLog events
Configure Cisco AXL sync
Configure TIM Plus to capture SysLog packets
Configuring UCME to send SysLog events
Use Telnet to connect to the IP address of your UCME as shown below:
Once connected, enter the following commands to enable the UCME to send SysLog events to TIM Plus:
Labels: