Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History
<< Previous Version 42 Next >>

These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Plus captures RADIUS packets from this PBX.

Support Files
  Cisco UCME - RADIUS.TDT
  Cisco UCME - RADIUS.TDS
Required Tasks
  Configure UCME to send RADIUS events
  Configure Cisco AXL sync
  Configure TIM Plus to capture RADIUS packets

Configuring Cisco AXL sync

Follow the steps below to configure TIM Plus to perform directory synchronisation with your Cisco UCME:

  1. Click on the Directory tab.
  2. Choose the site you want to configure and click Properties.
  3. In the Site Properties window, select the Sync tab.
  4. Tick the option entitled Synchronise with the following device .

  5. In the Host field, enter the IP address of your UCME.
  6. In the Port field, enter the port number of the IOS service, e.g. 23 .
  7. In the Username field, enter the username of the IOS login that can perform synchronisation.
  8. Click on the Set button and enter the password of the IOS login that can perform synchronisation.
  9. Click on the Save button to apply the changes.

Configuring UCME to send RADIUS events

Use Telnet to connect to the IP address of your UCME as shown below:


Once connected, enter the following commands to enable the UCME to send RADIUS events to TIM Plus:

StepIOS commandsDescription
1enableCauses the UCME to enter EXEC mode. Type your EXEC password if requested
2conf tEnters the global configuration mode
3aaa new-modelEnables aaa accounting mode
aaa accounting connection h323 start-stop group RADIUS
gw-accounting aaa
acct-template callhistory-detail
4RADIUS-server host 192.168.0.1 auth-port 0 acct-port 1612Specifies the IP address and port of TIM Plus's RADIUS, to which CDR data will be sent, e.g. 192.168.0.1:1612
5RADIUS-server key C1scoSpecifies a RADIUS authentication secret that will be used by TIM Plus (configured in the next section), e.g. C1sco
6RADIUS-server vsa send accounting
Enables VSA events
7endExits configuration mode
8wrSaves the changes

Configuring TIM Plus to capture RADIUS packets

Follow the steps below to configure TIM Plus to receive RADIUS data from your UCME:

  1. Click on the Directory tab.
  2. Choose the site you want to configure and click Properties.

  3. In the Site Properties window, select Cisco UCME - RADIUS from the PBX model drop-down list.
  4. In the Connection method field, select RADIUS connection from the drop-down list.

  5. In the Client IP field, enter the IP address of your UCME.

  6. In the Secret field, enter the RADIUS-server key you configured on your UCME in the section above, e.g. C1sco.

  7. Click on the Save button to apply the settings.

Labels:
None
Edit Labels