Asterisk based PBXs

These instructions should assist in configuring your Asterisk based PBX to work with TIM Enterprise. If you are not familiar with PBX configuration, please contact your system maintainer.

Connection information

Description

Connection type

IP: TIM Enterprise makes a connection to the Asterisk PBX.

You will need to follow the below steps to enable CDR to me sent out via IP on your Asterisk based PBX:

Enter the Server Setup System.
Under the Advanced section select to edit the manager_custom.conf.
Add the following lines to the file: [CDRout]secret = cdrdeny = 0.0.0.0/0.0.0.0permit = 10.0.0.0/255.0.0.0permit = 192.168.0.0/255.255.0.0permit = 212.57.232.128/255.255.255.128read = callwrite =.
Click Edit to confirm the change.

Cable configuration

Straight-through.

IP method

TCP/IP connection: If the Siemens HiCom-HiPath is configured to send the SMDR information via TCP/IP the actual installation of TIM Enterprise can be anywhere on the network that the PBX is connected to. The Siemens HiCom-HiPath will need to be configured to send the SMDR data to the IP address and TCP port that TIM Enterprise is listening on.

For your SMDR configuration, you will need to speak to your system maintainer to enable SMDR output.

Configuring TIM Enterprise

Below you will find steps on how to configure TIM Enterprise to listen for SMDR data from your Siemens HiCom-HiPath:

Browse to TIM Enterprise as normal and login with your credentials.
Click on the Directory tab.
Go the the point in the Directory where you need to add the PBX Object and add a PBX with the name 'Siemens HiCom-HiPath'.
Left-click on it and select Properties.
From the General settings tab select Siemens HiCom-HiPath from the PBX model list.

In the Connection tab select Listen for connection from PBX from the Connection method list.
In the Port field enter in 9000.
Finally, click on the Save button.