NEC NEAX - Serial connection

Tese instructions help you configure your NEC NEAX phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type

TIM Plus establishes a serial connection with this PBX.

Support Files

NEC NEAX.TDT

NEC NEAX.TDS

Required Tasks

Configure the SMDR output

Configure your serial connection

Install NetPBX

Configure TIM Plus

Configure your NEC NEAX

Enabling your SMDR output

Please speak with your phone maintainer to enable the SMDR output.

Configuring your Serial connection

Using the CAT (Customer Administration Terminal) in the system-programming mode, enter the following settings:

Field name

Details

CM40

Output port & attributes defaults: 9600 baud, 8 data bits, no parity, 2 stop bits, DTR/RTS flow control.

CM13+05

Enable SMDR for incoming calls to required stations.

CM13+06

Enable SMDR for outgoing calls to required stations.

CM35+14

Enable SMDR for outgoing calls to required trunk routes.

CM35+49

Enable SMDR for incoming calls to required trunk routes.

CM08

If SMDR for incoming calls is enabled, specify whether it applies to all incoming calls or only to those with Account Codes. Include ANI/Caller ID for incoming calls.

NOTE 1: The ANI/Caller ID is required to provide SMDR for incoming calls, even if this feature is enabled by CM13+05 and CM35+49.

NOTE 2: Use CDR formats #501 (2400 IMS), #505 (2000 IPS), #506 (2000 IVS).