You are viewing an old version of this page. View the current version.
Compare with Current ·
View Page History
These instructions help you configure your Mitel 3100 phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.
Connection Type
TIM Plus establishes a serial connection with this PBX.Support Files
Mitel 3100.TDTMitel 3100.TDS
Required Tasks
Configure the SMDR outputInstall NetPBX
Configure TIM Plus
Configuring your SMDR output
Below you will find the steps to configure your Mitel 3100 to output SMDR data via a serial connection:
- Using an RS-232 cable, connect the printer or PC to the call logging (SMDR) port on the front of the controller.
- Launch the system tool.
- Choose from the selection menu.
- Click on the tab, select , and then click .
- Set the following parameters:
- Set the Cost per minute to 00. This functionality is not supported in NA systems.
- Set the Minimum call duration to be recorded to 00:00:00.
- Set the Type of calls to All .This should be the default.e
- Set the Minimum page length to 1.
- Enable call logging.
- Click .
- You will need to 'commit' your changes before they take effect.
Installing NetPBX
The Mitel 3100 phone system sends SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Plus, you will first need to install the NetPBX software. For setup instructions, click on the link below:
Configuring TIM Plus
Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:
- Click on the tab.
- Select the site configured during the setup wizard and click
. - Within the Site Properties window, select Mitel 3100 from the PBX model drop-down list.
- In the Connection method field, select No connection required from the drop-down list.
- Click on the button to apply the settings.
Labels: